Linkskey LKV-9208IP - Manual (Page 21)

Prima IP User Guide Rev. 1.6
Configure display resolution on your server
Prima IP supports most display modes up to 1600 x 1200. However, you might encounter
some display problems when your display card is outputting an unusual display mode. These
possible problems are either no video or abnormal display on viewer screen.
To simplify the display factor before connection to Prima IP, we suggest you use more
standard display modes such as: 800 x 600 @ 60Hz/75Hz, 1024 x 768 @ 60Hz/70Hz,
etc. For the suggested display modes, please refer to the following table.
Note: These are suggested display modes for server desktop-connected Prima IP. However, the
actual display modes for as specific server desktop will be dependent on its display card.
Some display modes listed here might not be feasible with some display card. Try to do some
trials to determine the best display mode for your desktop on Prima IP viewer.
Disable special transition effects on the screen outputs of your connected servers
Go to Control Panel / Display / Appearance / Effects. And then uncheck the option to
disable transition effects such as Fade for the menus and tool tips. You should
perform the same check on each of your connected servers.
On Windows platforms such as Windows 98, 2000, XP and 2003 Server, some transition
effects might yield undesirable video refreshing artifacts, especially when you are using Medium or
Low Video Quality as your video filter settings. To avoid undesirable artifacts from appearing on your
screen, please turn off the special transition effects.
- 17 -