Bang & Olufsen BeoSystem 1 - Manual (Page 45)

45
See the active sound system
You can see the name of the active sound
system for the current source or programme
on the screen. However, it is not possible to
adjust or preset a sound system.
Modes available in a surround sound setup
SPEAKER1
Mono sound in the centre speakers only. Use
this mode e.g. for watching the news. The
subwoofer is always active in Speaker modes
2 – 5. Speaker mode 1 does not activate the
subwoofer, and is ideal for night listening.
SPEAKER2
Stereo sound in the front speakers. Use this
mode when you listen to an audio-only source,
such as a CD, from a connected audio system.
This mode is selected automatically for audio-
only sources.
SPEAKER3
Stereo sound in the front speakers with the
mono sound of e.g. speech and sound effects
concentrated in the centre speakers. Use this
mode when you watch TV programmes
broadcast in stereo.
SPEAKER4
Enhanced stereo sound in the front and rear
speakers. Use this mode when you want e.g. an
enhanced effect of the stereo sound on a CD.
SPEAKER5
Surround sound reproduced by all the speakers
in the system together. Use this mode when you
want to experience the full effect of surround
sound when watching a programme or movie
encoded with Pro Logic, DTS or Dolby Digital, or
when listening to a CD pre-recorded with one of
the sound systems.
To call up the SOUND SYSTEM menu…
> Press MENU on Beo4 to call up the main
TV SETUP menu.
> Press GO to call up the SOUND menu.
> Press 6 to call up the SOUND SYSTEM menu.
The current sound system is shown on the
screen. MONO/STEREO appears if no Dolby or
DTS sound variant is currently active.
> Press EXIT or a source button, e.g. TV or SAT,
to exit all on-screen menus.
The SOUND SYSTEM menu
Sound systems that can appear in the menu are:
DOLBY DIGITAL, DOLBY PRO LOGIC, DOLBY 3
STEREO, DOLBY DIGITAL + DOLBY PRO LOGIC,
DTS and MONO/STEREO.
Change speaker mode
You can select a speaker mode at any time,
even if you have preset a default speaker
mode, or if a programme causes a speaker
mode to be selected automatically. In most
cases, the speaker mode you select applies
until you switch BeoSystem 1 to standby.
When SPEAKER is displayed in the Beo4 display, it
is also possible to adjust the balance between the
loudspeakers. Please refer to ‘Adjust sound and
picture settings’ for further information.
LIST
SPEAKER
1 – 5
EXIT
?
Press LIST repeatedly until
SPEAKER is shown in the Beo4
display
Use the number buttons to select
the speaker mode you want
Press to exit the SPEAKER
function
TV SETUP
1 SOUND
2 PICTURE
3 CLOSED CAPTIONING
4 PARENTAL CONTROL
5 RECORD LOCK
6 EXTERNAL SOURCES
7 FIRST TIME SETUP
8 RF / CHANNEL SETUP
select
SOUND
1 ADJUSTMENT
2 SPEAKER TYPE
3 SPEAKER DISTANCE
4 SPEAKER LEVEL
5 SPEAKER MODE
6 SOUND SYSTEM
select