Lanner IPMI - Manual (Page 5)

B-FOCUS 442 GW User Manual
3
About this product
Purpose
The purpose of this document is to connection and management information for IP KVM-IC2300 through IPMI
service.
Intended audience
This document is for individuals who configure and manage IP KVM-IC2300.
How to use this document
Use this guide to install or configure the IPMI service on the server system.
Safety information
WARNING: The following information lists the safety reminders for installation and maintenance personnel.
Read all instructions before attempting to unpack, install, operate, or connect power to this product. Please remember
the following when you unpack and install this equipment:
„ Keep the chassis area clear and dust-free during and after the installation. Do not wear loose clothing or
jewelry that could get caught in the chassis.
„ Fasten your tie or scarf and roll up your sleeves.
„ Wear safety glasses if you are working under any conditions that might be hazardous to your eyes.
„ Do not perform any action that creates a potential hazard to people or makes
the equipment unsafe.
„ Disconnect all power by turning off the power and unplugging the power cord before installing or removing a
chassis or working near power supplies
„ Do not work alone if potentially hazardous conditions exist.
„ Never assume that power is disconnected from a circuit; always check the circuit.
Operating Safety
„ Electrical equipment generates heat. Ambient air temperature may not be adequate to cool equipment to
acceptable operating temperatures without adequate circulation. Be sure that the room in which you choose to
operate your system has adequate air circulation.
„ Ensure that the chassis cover is secure. The chassis design allows cooling air to circulate effectively. An open
chassis permits air leaks, which may interrupt and redirect the flow of cooling air from internal components.
„ Electrostatic discharge (ESD) can damage equipment and impair electrical circuitry.
„ ESD damage occurs when electronic components are improperly handled and can result in complete or
intermittent failures. Be sure to follow ESD –prevention procedures when removing and replacing components
to avoid these problems.
„ Wear an ESD-preventive wrist strap, ensuring that it makes good skin contact.
„ If no wrist strap is available, ground yourself by touching the metal part of the chassis.
„ Periodically check the resistance value of the antistatic strap, which should be between 1 and 10 megohms
(Mohms).
EMC Notice
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case users will be required to correct the interference at their own expense.