Yaskawa MP2000 Series - Manual (Page 14)

Page 14
TM.MP2000.02, 1/18/2011
Data subject to change without notice
Yaskawa America, Inc.
Á
1.7 Default Parameters at Initial Startup
PCLINK Interface (INIT ON enabled only at power ON)
Parameter Item INIT SW = ON
Local Station Number This follows the rotary switch address settings.
(In cases where the setting is out of range, a switch setting error will
result *1)
Group Number 160
Token Holding Time 10 ms
Token Monitoring Time 500 ms
Station Search Time 1000 ms
Discrete Offset 800 H
MEMOBUS Monitoring Time 0
Retry Count 0
Baud Rate This follows the DIP switches.
*1 Although the setting of an individual station number and baud rate is performed according to the content of switch
setting during self-configuration in a state wherein the transmission definitions have not been set, in cases where an
individual station number setting is outside the range, an error will result during self-configuration, and boot-up will not
be normal. In this case, make the correct settings.
An error will result when any of the following switches are set.
• Station Address Setting of Rotary Switches S2 and S3: set to 0 or 33 or more
RS–232C Interface (INIT ON enabled only at power ON)
Parameter Item INIT SW = ON
Transmission Protocol MEMOBUS
Master/Slave Slave
Device Address 1 Á According to the rotary switch.
Transmission Mode RTU
Data Length 8 bits
Parity Bits Even number
Stop Bits 1 bit
Baud Rate 19.2 kbps Á Á Á According to the DIP switches.
Always fixed,
except for
the switch