Yaskawa Portable Control Display Unit - Manual (Page 65)

7 FORCING MENU
59 Forcing (FRC) Menu
01/22/96
If a valid forcible block number was
entered, the PCDU will display the
following screen:
This display indicates that the operator
must press either F1, F2, or F3. The F1
key is used to enter a new Forcing Value
for the selected block. The F2 and F3 keys
are used to choose whether the selected
block will get the forcing value or the
normal value. When the F2 = FORCE
flashes, the block is getting the forced
value. When the F3 = NORM flashes, the
block is getting the normal value.
If the F1 key is pressed, the PCDU will
display either a numeric (NUMI, NUMO,
REFO, TACH, RDCI) or a logical PAC
block (LOGI, LOGO).
Example:
For this example, a NUMI and a LOGO
block will be used.
• Press the F1 key. The PCDU display
will be:
(NUMI PAC BLOCK)
(LOGO PAC BLOCK)
OR
This display shows the block type (NUMI
or LOGO) followed by the block number
LOGO Block 00444
OFF
NUMI Block 00200
55.
F1 = Set New Val
F2 = Force
F3 = NORM