Yaskawa Portable Control Display Unit - Manual (Page 40)

6 TEST MENU
34 The Trace Monitor Function
01/22/96
If the desired pack block exists, the PCDU
has two possible displays.
1. If the PAC block has one or more
inputs and/or outputs, the display
will be:
2. If the PAC block has a single input
or a single output, the PCDU will
directly display the contents of the
Trace Buffer for the selected PAC
block.
For the first type of display, press F1 or F2
to select either an input or an output of a
PAC block. The PCDU displays one of the
two following screens, depending on
whether F1 or F2 was pressed.
F1
F2
Note that the number in the brackets is the
I/O number of the PAC block that the Trace
Monitor is currently set up to view.
• For this example, press the F1 key
followed by the 3 key to select input
# 3 of PAC block # 243.
• Press ENT.
ENTER OUTPUT [02]
NEW :
ENTER INPUT [02]
NEW :
F1 = Block Input
F2 = Block Output