Yaskawa SI-EN3 Installation - Manual (Page 9)

YASKAWA ELECTRIC TOBP C730600 58B 1000-Series Option SI-EN3 Installation Manual 9
3 Receiving
3 Receiving
Please perform the following tasks upon receipt of the option:
• Inspect the option for damage. Contact the shipper immediately if the option appears
damaged upon receipt.
• Verify receipt of the correct model by checking the model number printed on the name
plate of the option package.
• Contact your supplier if you have received the wrong model or the option does not
function properly.
◆
Option Package Components
Table 2 Option Package Contents
◆
Tools Required for Installation
• A Phillips screwdriver (M3 metric/#1, #2 U.S. standard size
<1>
) is required to install the
option and remove drive front covers.
• Diagonal cutting pliers. (required for some drive models)
• A small file or medium grit sandpaper. (required for certain drive models)
Note: Tools required to prepare option networking cables for wiring are not listed in this manual.
Description: Option
Ground
Wire
Screws (M3) LED Label Installation Manual
_
Quantity: 1 1 3 1 1
<1> Screw sizes vary by drive capacity. Select a screwdriver appropriate for the drive capacity.
NS MS MANUAL
EtherNet_IM_E_conditional.fm 9 ページ ２０１２年１０月３１日 水曜日 午後１２時５３分