Yaskawa 1000 Series Drive Option - Profibus-DP Technical Manual - Manual (Page 8)

8 YASKAWA ELECTRIC SIEP C730600 42B 1000-Series Option SI-P3 Technical Manual
4 Option Components
4 Option Components
‹ PROFIBUS-DP SI-P3 Option
Figure 1
Figure 1 PROFIBUS-DP Option Components
‹ Communication Connector CN5
The drive has a 9-pin D-sub connector to connect to a PROFIBUS network.
Table 3 Communication Connector Description (9-pin D-sub)
A – Communication cable connector F – LED (COMM) <1>
B – Model number G – LED (BF) <1>
C – Connector (CN5) H – LED (ERR) <1>
D – Installation hole I – Ground terminal and installation hole <2>
<1> Refer to Option LED Display on page 9 for details on the LEDs.
<2> The ground wire provided in the option shipping package must be connected during installation.
E – LED (RUN) <1>
PROFIBUS Connector Pin Signal Description
1 Shield Connected to the metal-shell (no direct FG-connection)
2 – –
3 RxD/TxD-P Receive/Transmit data; line B (red)
4 CNTR-P Control signal for repeaters (direction control)
5 DGND Data ground (reference voltage to VP)
6 VP Power supply output for bus termination (for termination resistor)
7 – –
8 RxD/TxD-N Receive/Transmit data; line A (green)
9 – –
C A B
D
E
F
H G I
SI-P3
CN5 connector bottom view
Underside
1
5
6
9
Bottom View
7
8
2
3
4