Yaskawa 1000 Series Drive Option - MECHATROLINK-II Technical Manual - Manual (Page 11)

5 Installation Procedure
YASKAWA ELECTRIC SIEP C730600 50A YASKAWA AC Drive-Option Card MECHATROLINK-II Technical Manual 11
‹ Wiring the Network Cable Connectors
Figure 1
Figure 2 Wiring Diagram
Damage to Equipment
Properly connect connectors.
Failure to comply may prevent proper operation and possibly damage equipment.
Check wiring to ensure that all connections are correct after installing the option card and connecting any other
devices.
Failure to comply may result in damage to the option card.
<1> The FE terminal on the MECHATROLINK-II Option is supplied with a ground cable that should be connected to the ground terminal on the
drive.If there are noise influences on communication, remove the grounding cable.
NOTICE
SI-T3
CN3
FE
NC
SRD−
SRD+
NC
NC
SRD−
SRD+
NC
NC
SRD−
SRD+
NC
MECHATROLINK
Master Drive
Terminator
MECHATROLINK-II
Communication
Cable
shielded line control circuit terminal
<1>