SMA SI 3324 - Manual (Page 21)

SMA Technologie AG Operation / Commisioning
User Manual SI3324/4248-14:FE2406 Page 21
After a successful startup, a status overview
appears in the display, showing the present
operating mode and the output power (see also
figure to the right):
You can now call up the various menus using the control elements (see section 4.1
"Control Elements" (page 17)) in order to view the measurement values and the
parameter settings.
4.2.2 Stopping
Proceed as follows to set the Sunny Island 3324/4248 to standby mode:
1. Switch off all loads, as far as this is possible.
2. Press and hold the "ESC" key until the "To
stop press ENTER" message appears.
3. Press "ENTER".
4. The Sunny Island 3324/4248 stops and
enters standby mode.
5. The message "To start press " is
displayed. The green LED on the control
panel of the Sunny Island 3324/4248 goes
out.
4.2.3 Deactivation
To switch off the Sunny Island 3324/4248, proceed as follows:
Note that all connected loads are no longer provided with
electrical energy once you have stopped the Sunny Island 3324/
4248.
Note that in standby mode there is still voltage present in the
inverter (DC, AC input).
Even in standby mode, the Sunny Island 3324/4248 still requires about 4 W
of power from the battery.
Waiting
[¿__________]
Invert oo
To stop
press
To start
press