2 transporting and mounting the grid connect box – SMA GRID CONNECT BOX 12 User Manual
Page 16
5 Installation
SMA Solar Technology AG
16
GRID-BOX-12-3-20-BE-en-10
Operating Manual
5.4.2 Transporting and Mounting the Grid Connect Box
Additionally required mounting material (not included in the scope of delivery):
☐ 4 suitable bolts to attach the Grid Connect Box to the support surface
Procedure:
1. Remove all fastening screws from the kick plates at the front and rear (TX 30).
2. Remove kick plates
3. Retain the kick plates and the fastening screws for later use.
4. Slide the means of transport underneath the Grid Connect Box and transport the Grid Connect Box to the mounting
location.
:$51,1*
Danger of crushing if the raised or suspended Grid Connect Box topples or falls
The Grid Connect Box can topple or fall if it is lifted and transported carelessly or hastily. This can result in death or
serious injury.
• Always transport the Grid Connect Box as close to the ground as possible.
• Use means of transportation which are adequate for the weight of the Grid Connect Box of 103 kg.
• Transport the Grid Connect Box in an upright position.
• Always maintain an adequate safety distance from the Grid Connect Box during transport.
• Note the center of gravity of the Grid Connect Box. The center of gravity of the Grid Connect Box is located
approximately in the center of the cabinet and is marked on the enclosure with the center of gravity symbol.
/05*$&
Damage to the Grid Connect Box due to inappropriate transport
If the Grid Connect Box is set down on an uneven surface, it may warp so that the doors will no longer close properly.
This can lead to moisture and dust penetrating the Grid Connect Box.
• Never place the Grid Connect Box on an unpaved, uneven surface.
• Never transport the Grid Connect Box with mounted kick plates.
5.
&$87,21
Risk of injury if the Grid Connect Box tips over
The Grid Connect Box is heavy and may tip over if not properly fastened to the support surface. This can result in
crushing injuries.
• Attach the Grid Connect Box to the support surface using four suitable bolts.