Excalibur electronic P95-LP3 - Manual (Page 28)

Excalibur ® P95-3 Zero Clearance Direct Vent Gas Fireplace 28
Pin
INSTALLATION
Place embers on the burner tray.
DO NOT BLOCK BURNER HOLES
13) Test fi re to ensure proper light off (make
sure fl ame fl ows smoothly from one end of
burner to the other). If there is any fl ame
hesitation, check that area for any blockage
of the burner ports.
14) Reverse steps 1-3 under the "Optional Brick
Panels" section.
10) Place the top of Log 309 on Log 308,
supported by the knot.
11) Fit Log 310 on the pin and then swing the
front end of the log to hit the fi rst grate
12) Place the embers on the front of the burner
tray.
309
308
311
310
306
Rear Log
309
Middle Right Log
307
Middle Left Log
310
Front Left Log
312
Front Bottom Log
308
Center Right Log
311
Center Left Log
Knot
9) Place the back of Log 309 against the bracket
on the top right side of the burner.
The picture below is a view from the back
of the burner.
Rest log against
bracket
8) Place the top of Log 307 across the notch
on Log 311.
Notch
311
307
306
309