Excalibur electronic P95-LP3 - Manual (Page 25)

Excalibur ® P95-3 Zero Clearance Direct Vent Gas Fireplace 25
INSTALLATION
12) Reverse steps 6) to 1).
13) Attach the label "This unit has been
converted to LPG near or on top of the
serial # decal.
14) Replace yellow "Natural Gas" label with
red "LPG" label.
WARNING!
Do not overtighten the screw.
Recommended to
grip the wrench by the short side.
12) Insert a 5/32” or 4mm Allen wrench into
the hexagonal key-way of the screw
(Fig. 2), rotate it counter-clockwise until
it is free and extract it.
13) Check that the screw is clean and if
necessary remove dirt.
14) Flip the screw (Fig. 3).
15) Using the Allen wrench as shown in
Fig.4, rotate the screw clockwise until
snug, do not overtighten.
16) Verify that if the conversion is from
NG to LPG, the screw must be re-
assembled with the red o-ring visible
(Fig. 5).
17) Re-assemble the black protection cap
(Fig. 6).
WARNING!
Also check that the pilot and main
burner injectors
are appropriate for the gas type.
Fig.2
Fig.3
Fig.4
LPG Configuration
Red o-ring visible
Fig.5
Fig. 6
Installation of the DC Sparker:
15) Locate the Piezo Ignitor situated at the side
of valve.
16) Remove the Piezo Ignitor by unscrewing the
nut at the back of the mounting bracket.
17) Disconnect the ignitor wire from the Piezo
Ignitor and connect it to the DC Sparker.
Piezo
Ignitor
Ignitor
Wire
Piezo
Ignitor
Ignitor
Wire
DC
Sparker
18) Install the 3/4" nylon plug to cover up the
hole on the mounting bracket.