Excalibur electronic P95-LP3 - Manual (Page 26)

Excalibur ® P95-3 Zero Clearance Direct Vent Gas Fireplace 26
INSTALLATION
30) Check inlet and outlet pressures.
31) Check operation of fl ame control.
32) Check for proper fl ame appearance and
glow on logs.
Installer Notice:
These instructions must be
left with the appliance.
19) Connect the DC spark generator wires
to the SIT Valve with the screw, which is
provided in the kit.
20) Locate the ground lug at the receptical box,
left of the unit.
21) Connect one end of the supplied green
ground wire to the lug with the nut and
washer from the kit.
22) Install the 1/2" bushing to the heat
shield.
Ground
wire from
kit
24) Plug the DC spark generator wires to the
DC Sparker.
25) Connect the ground wire to the DC Sparker
mounting bracket.
27) Mount the heat shield to the DC Sparker.
Secure into place with the velcro, which is
provided in the kit.
Heat Shield
23) Run the other end of the ground wire and
DC spark generator wires through the
bushing on the heat shield.
29) Tie up the loose wire with the wire clip.
28) Find a location which is not too hot and
is easy to reach for changing the battery.
26) Install the supplied battery into the DC
Sparker Box by opening the battery
compartment.
NOTE: The battery in the DC Sparker Box
will need to be replaced annually.
Battery
Compartment