Excalibur electronic P95-LP3 - Manual (Page 13)

Excalibur ® P95-3 Zero Clearance Direct Vent Gas Fireplace 13
SIMPSON DURA-VENT VENTING
The Simpson Dura-Vent Direct Vent System offers a complete line of component parts for installation of both horizontal and vertical installations.
Many items are offered in decorative black, as well as galvanized fi nish. We recommend using the galvanized fi nish for installation with the
P95-3.
The minimum components required for a basic horizontal termination are:
1 Horizontal Termination Cap
1 90 o Elbow
1 Flue Adaptor
1 Wall Thimble
1 Length of pipe to suit wall thickness
(see
chart)
Wall thickness is measured from the back standoffs to the inside mounting surface
of termination cap. For siding other than vinyl furring strips may be used, instead
of the vinyl siding standoff, to create a level surface to mount the vent terminal.
The Terminal must not be recessed into siding. Measure the wall thickness
including furring strips.
If a Vinyl Siding Standoff is required (it must be used with vinyl siding), measure
to outside surface of wall without siding and add 2 inches.
INSTALLATION
Horizontal and Vertical
Terminations for 5" x 8" Venting
Alternate Horizontal
Termination Cap
Simpson
Dura-Vent
Direct Vent GS
The FPI AstroCap XL TM is certifi ed for installations using
FPI venting systems as well as Simpson Dura-Vent® and
Direct Vent GS.
The FPI AstroCap XL TM is a proprietary trademark of FPI
Fireplace Products International Ltd.
Dura-Vent® and Direct Vent GS are registered and/or
proprietary trademarks of Simpson Dura-Vent Co. Inc.
Flat Wall Installation
Wall Thickness
(inches)
Vent Length Required
(inches)
4" - 5-1/2" 6"
7" - 8-1/2" 9"
10" - 1-1/2" 12"
9" - 14-1/2" 11" - 14-5/8" Adj. Pipe
15" - 23-1/2" 17" - 24" Adj.
Corner Installation
Wall Thickness
(inches)
Vent Length Required
(inches)
3-1/4" - 6-3/4" 11" - 14-5/8" Adj. Pipe
7-3/4" - 16-1/4" 17" - 24" Adj. Pipe
7-1/4" - 8-3/4" 6" + 12"
9" + 9"
4-1/4" - 5-3/4" 6" + 9"