ShoreLand'r SLB60TAL - Manual (Page 8)

Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028 www.shorelandr.com 0004303
Page 8 of 13 2/15/2011
B
S
rake Line Installation
ort all of the items in brake kit box.
ocate the long (90’) brake lines
nd straighten out by uncoiling.
and 1/4”
n the
it.
plug from
e fitting into this port making sure that the line does not
e bolt in the brass block if it has been loosened to rotate
back side of the axle and secure to the axle with the five
Note that the axle is pre-drilled for the mounting screws.
ss block on the right brake caliper. Remove both plugs on
her end of the brake hose into the bottom port on the
g.
e
cond axle. Tighten.
emove the plastic cap from the end of the frame brake hose coming out of the side frame by
se enough so that it will reach the top port of the tee just
ad the brake hose fitting into the top port of the tee installed
ther port on the tee. Route the hose over to the brake line
nd then down and thread into the side port on the brass
To prevent the hose from sagging and getting caught on
L
a
Locate five (5) line clamps
elf tapping screws provided i s
k
Remove the lower plastic
the port in the brass block on the
left brake caliper. Note also that the
bolt holding the brass block to the
caliper can be loosened so that the
brass block can be rotated to better
accommodate the angle that the
brake hose approaches the block
on the caliper. Thread the brake hos
rub or touch the spring. Re-tighten th
the block. Route the hose along the
(5) clamps and self tapping screws.
Route the brake hose over to the bra
the right caliper block. Thread the ot
brass block. Thread the 18” brake hose male end into the other port. Tighten.
Set the position the brass block so that no components will make contact or rub on the sprin
Tighten all fittings.
Place the other end of the hose up
through the hole provided in the
brake line clip bracket. Secure in
place with the hose clip provided.
Repeat this process on the second
axle.
Connecting the Axles Together
Locate the brass tee. Thread the
male port of the tee into the femal
end of the 18” brake hose running
up from the axle just installed on
the se
R
the axle. Carefully pull the brake ho
e threaded into the brake hose. Thr
on the second axle and tighten.
Thread the 60” brake hose into the o
clip thru the large hole on the end a
block. Tighten these connections.
things take two (2) clamps and two (2) self-tapping screws and attach to the I-beam.