ShoreLand'r SLB60TAL - Manual (Page 4)

Spring Bracket Bushing
assembly. Secure with a 9/16” x 3-1/4” hex bolt and lock
nut.
Install the spring bracket bushing into the spring
support channel. This assembly is then inserted into the
rear spring bracket shackle and secured with a 9/16” X
4-3/4” stainless steel hex bolt and 9/16” stainless steel
hex lock nut with nylon insert. Repeat this procedure on
the other spring bracket on the opposite side of the
trailer.
Axle:
Note: The hook end of the springs must be toward the rear of the trailer, on both axles!
Position the axles so they are properly aligned
with the trailer. Position the brake axle so that the
disc brake calipers are on the back side of the
axle. Place the springs on the topside of the spring
pads welded to the axle. Place a spring clamp on
the top center of the spring. Place the 1/2” x 6-1/2”
stainless steel square U-bolts down over the top of
the spring clamp, spring and axle.
Place the spring and axle U-bolt plate onto the
ends of the two U-bolts. Secure in place with 1/2”
stainless steel lock nuts. Thread onto the U-bolts
but do not tighten securely until the complete unit
is in position on the trailer. Repeat on the other
spring.
Hook on
leaf spring
& Brake
Caliper to
the rear of
Trailer
Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028 www.shorelandr.com 0004303
Page 4 of 13 2/15/2011