ShoreLand'r SLB60TAL - Manual (Page 3)

Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028 www.shorelandr.com 0004303
Page 3 of 13 2/15/2011
Assembly Instructions
Rocker Bushings and/or Bogie:
Note there is a grease zerk in the center bushing of
the rocker bogie. Position the rocker bogie into the
center mounting channel of the spring bracket so
that the grease zerk is pointing down. This is
necessary so that it can be serviced in the field
when needed. Align the center hole of the rocker with
the center hole of the spring bracket. Insert and secure
with a 3/4” X 4-1/2” stainless steel hex bolt from the
outside in and tighten with a 3/4” stainless steel hex lock
nut.
Install the 3/4” ID X 1” OD X 1-1/2” bronze bushings
into the inside the rocker matching the middle and rear
hole patterns. The middle rocker
bushing must be secured with a 3/4” X
5-1/2” stainless steel hex bolt through
the rocker, bushing and the middle
shackle on the spring bracket. Tighten
using a 3/4” stainless steel hex lock nut
with nylon insert. The front rocker
bushing must be secured with a 9/16”
X 3-3/4” stainless steel hex bolt and
9/16” stainless steel hex lock nut with
nylon insert. Repeat this procedure o
the other rocker on the opposite side of
the trail
n
er.
Spring Bracket Bushings:
Place one of the spring bracket bushings into the rear of the spring bracket and secure with a
9/16” x 3 1/4” stainless steel hex bolt and 9/16” stainless steel hex lock nut. Repeat in other
spring bracket. Install another spring bracket bushing in the front hole on the rock arm
Rocker/Boogie 8200#
Trailer
To Front of
Trailer