HEIDENHAIN TNC 640 (34059x-05) - Manual (Page 42)

Contents
42
TNC 640 | User's Manual
HEIDENHAIN Conversational Programming | 1/2015
15 Manual operation and setup.......................................................................................................515
15.1 Switch-on, switch-off..........................................................................................................................516
Switch-on............................................................................................................................................... 516
Switch-off...............................................................................................................................................518
15.2 Moving the machine axes.................................................................................................................. 519
Note....................................................................................................................................................... 519
Moving the axis with the machine axis direction buttons.................................................................... 519
Incremental jog positioning...................................................................................................................519
Traverse with electronic handwheels....................................................................................................520
15.3 Spindle speed S, feed rate F and miscellaneous function M......................................................... 530
Application............................................................................................................................................. 530
Entering values......................................................................................................................................530
Adjusting spindle speed and feed rate................................................................................................. 531
Activating feed-rate limitation............................................................................................................... 531
15.4 Optional safety concept (Functional safety FS)............................................................................... 532
Miscellaneous........................................................................................................................................532
Explanation of terms............................................................................................................................. 533
Checking the axis positions.................................................................................................................. 534
Activating feed-rate limitation............................................................................................................... 534
Additional status displays......................................................................................................................535
15.5 Datum management with the preset table......................................................................................536
Note....................................................................................................................................................... 536
Saving the datums in the preset table................................................................................................. 537
Activating the datum............................................................................................................................. 542
15.6 Datum setting without a 3-D touch probe.......................................................................................543
Note....................................................................................................................................................... 543
Preparation.............................................................................................................................................543
Setting datum with an end mill............................................................................................................ 543
Using touch probe functions with mechanical probes or measuring dials............................................544