HEIDENHAIN TNC 320 (340 55x-04) - Manual (Page 63)

HEIDENHAIN TNC 320 63
2.4 Stat
us Displa
ys
2.4 Status Displays
“General” status display
The status display in the lower part of the screen informs you of the
current state of the machine tool. It is displayed automatically in the
following modes of operation:
„ Program Run, Single Block and Program Run, Full Sequence, except
if the screen layout is set to display graphics only, and
„ Positioning with Manual Data Input (MDI).
In the Manual mode and Electronic Handwheel mode the status
display appears in the large window.