HEIDENHAIN TNC 320 (340 55x-04) - Manual (Page 482)

482
Calling the file manager while the CYCLE
DEF
and TOUCH PROBE menus are active
Terminates the editing process and
calls the file manager. The respective
soft-key row remains selected when
the file manager is exited. Error message Key non-functional
Calling the file manager while
CYCL CALL
, SPEC FCT, PGM CALL and
APPR/DEP menus are active
Terminates the editing process and
calls the file manager. The respective
soft-key row remains selected when
the file manager is exited. Terminates the editing process and
calls the file manager. The basic
soft-key row is selected when the file
manager is exited.
Datum table:
„ Sorting function by values within an
axis
„ Resetting the table
„ Hiding axes that are not present
„ Switching the list/form view
„ Inserting individual line
„ Transfer of actual position values in
individual axis to the datum table per
keystroke
„ Transfer of actual position values in
all active axes to the datum table per
keystroke
„ Using a key to capture the last
positions measured by TS
„ Entry of comment in DOC column
„ Available
„ Available
„ Not available
„ Switchover via split-screen key
„ Allowed everywhere, renumbering
possible after request. Empty line is
inserted, must be filled with zeros
manually
„ Not available
„ Not available
„ Not available
„ With the "Edit the current field"
function and the on-line keyboard
„ Not available
„ Not available
„ Available
„ Switchover by toggle soft key
„ Only allowed at end of table. Line
with value 0 in all columns is inserted
„ Available
„ Available
„ Available
„ Via ASCII keyboard
FK free contour programming:
„ Programming of parallel axes
„ Automatic correction of relative
references
„ With X/Y coordinates, independent of
machine type; switchover with
FUNCTION PARAXMODE
„ Relative references in contour
subprograms are not corrected
automatically
„ Machine-dependent with the existing
parallel axes
„ All relative references are corrected
automatically
Function TNC 320 iTNC 530