HEIDENHAIN TNC 320 (340 55x-04) - Manual (Page 366)

366 Manual Operation and Setup
12.5 Using 3-D T
ouc
h Pr
obes (T
ouc
h Pr
obe F
u
nction Sof
tw
a
re
Option)
12.5 Using 3-D Touch Probes
(Touch Probe Function
Software Option)
Overview
The following touch probe cycles are available in the Manual Operation
mode:
Function Soft key Page
Calibrate the effective length Page 370
Calibrate the effective radius Page 371
Measure a basic rotation using a line Page 373
Set the datum in any axis Page 375
Set a corner as datum Page 376
Set a circle center as datum Page 377
Touch probe system data management See User’s
Manual for
Cycles
When running touch probe cycles, no cycles must be
active for coordinate transformation (Cycle 7 DATUM,
Cycle 8 MIRROR IMAGE, Cycle 10 ROTATION, Cycles 11
and 26 SCALING and Cycle 19 WORKING PLANE).
For more information about the touch probe table, refer to
the User’s Manual for Cycle Programming.