HEIDENHAIN TNC 320 (340 55x-04) - Manual (Page 494)

494
PLANE function:
„ TABLE ROT /COORD ROT not defined
„ Machine is configured for axis angle
„ Programming an incremental spatial
angle according to PLANE AXIAL
„ Programming an incremental axis
angle according to PLANE SPATIAL if
the machine is configured for spatial
angle
„ Configured setting is used
„ All PLANE functions can be used
„ Error message is issued
„ Error message is issued
„ COORD ROT is used
„ Only PLANE AXIAL is executed
„ Incremental spatial angle is
interpreted as an absolute value
„ Incremental axis angle is interpreted
as an absolute value
Special functions for cycle
programming:
„ FN17
„ FN18
„ Function available, details are
different
„ Function available, details are
different
„ Function available, details are
different
„ Function available, details are
different
Function TNC 320 iTNC 530