HEIDENHAIN TNC 320 (340 55x-04) - Manual (Page 480)

480
419, Datum in one axis X X
420, Measure angle X X
421, Measure hole X X
422, Measure circle outside X X
423, Measure rectangle from inside X X
424, Measure rectangle outside X X
425, Measure inside width X X
426, Measure ridge outside X X
427, Boring X X
430, Measure bolt hole circle X X
431, Measure plane X X
440, Measure axis shift – X
441, Fast probing – X
450, Save kinematics – X
451, Measure kinematics – X
452, Preset compensation – X
480, Calibrate TT X X
481, Measure/Inspect the tool length X X
482, Measure/Inspect the tool radius X X
483, Measure/Inspect the tool length and the tool radius X X
484, Calibrate infrared TT – X
Cycle TNC 320 iTNC 530