HEIDENHAIN TNC 320 (340 55x-04) - Manual (Page 467)

HEIDENHAIN TNC 320 467
Constant contouring speed: Relative to the path of the tool center
or relative to the tool's cutting edge X X
Parallel operation: Creating programs while another program is
being run X X
Programming of counter axes – X
Tilting the working plane (Cycle 19, PLANE function) Option #08 X, option #08 with
MC 420
Machining with rotary tables
„ Programming of cylindrical contours as if in two axes
„ Cylinder Surface (Cycle 27)
„ Cylinder Surface (Cycle 28)
„ Cylinder Surface Ridge (Cycle 29)
„ Cylinder Surface External Contour (Cycle 39)
„ Feed rate in mm/min or rev/min
„
„ X, option #08
„ X, option #08
„ X, option #08
„ –
„ X, option #08
„
„
X, option #08 with MC 420
„ X, option #08 with MC 420
„ X, option #08 with MC 420
„ X, option #08 with MC 420
„ X, option #08 with MC 420
Traverse in tool-axis direction
„ Manual operation (3-D ROT menu)
„ During program interruption
„ With handwheel superimpositioning
„ –
„ –
„ –
„ X, FCL2 function
„ X
„ X, option #44
Approaching and departing the contour: Via a straight line or arc X X
Entry of feed rates:
„ F (mm/min), rapid traverse FMAX
„ FU (feed per revolution mm/rev)
„ FZ (tooth feed rate)
„ FT (time in seconds for path)
„ FMAXT (only for active rapid traverse pot: time in seconds for path)
„ X
„ X
„ X
„ –
„ –
„ X
„ X
„ X
„ X
„ X
FK free contour programming
„ Programming for workpiece drawings not dimensioned for
NC programming
„ Conversion of FK program to conversational dialog
„ X
„ –
„ X
„ X
Program jumps:
„ Maximum number of label numbers
„ Subroutines
„ Nesting depth for subprograms
„ Program section repeats
„ Any desired program as subroutine
„ 65535
„ X
„ 20
„ X
„ X
„ 1000
„ X
„ 6
„ X
„ X
Function TNC 320 iTNC 530