HEIDENHAIN NPD 281 v.3 - Manual (Page 22)

22
List of Operating Parameters
Parameter Settings / Function
Enter code number 95 148 to change
protected operating parameters
Unit of measurement
Display in millimeters
Display in inches
Sorting and tolerance checking
Sorting into classes ON
Sorting into classes OFF
Lower limit for sorting
Upper limit for sorting
Display for series of measurements
MIN MAX ACTL DIFF
Display stop for measured value output
Concurrent display, no display freeze;
the display value is the current actual
value
Frozen display; hold display until next
measured value output
Frozen/concurrent display; freeze display
as long as Pulse/Contact for measured
value output is present
Parameter Settings / Function
Counting direction
Positive counting direction
with positive direction
of traverse
Negative counting direction
with positive direction
of traverse
Subdivision of the
encoder signals
400 / 320 / 256 / 200 / 160 / 128 / 100
80 / 64 / 50 / 40 / 20 / 10 / 8 / 5 / 4 / 2 / 1
0.8 / 0.5 / 0.4 / 0.2 / 0.1
Counting mode
0 - 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9
0 - 2 - 4 - 6 - 8
0 - 5
Decimal places
1 / 2 / 3 / 4 / 5 / 6
(up to 8 with display in inches)
List of Operating Parameters