HEIDENHAIN NPD 281 v.3 - Manual (Page 10)

10
Starting a series of measurements
Select the display for a series of
measurements.
The selected indicator blinks (here, MAX).
Confirm selection.
repeatedly
MOD
... until the indicator START blinks.
MOD
repeatedly
Switching between MIN, MAX, DIFF and ACTL displays
It is not possible to switch between the displays
as described below if the switching input for
external control of the series of measurements
(pin 6 on
D-sub connection EXT) is active.
As an alternative, you can select the display with operating
parameter P21 (see “Operating Parameters”).
Select the new display of a series of
measurements.
The selected indicator blinks (here, MIN).
Confirm the change.
repeatedly
MOD
The display now shows the smallest value measured during
the current series of measurements.
MAX
MIN
Indicator preselection
Press MOD to start the series of measurements and select
the display with the indicators.
Operating parameter P86 allows you to define which indicator
is displayed first when MOD is pressed.
Start the series of measurements.
START
Finding Minimum and Maximum Values