Polaris 2001 ATV Universal ATV - Manual (Page 176)

165
MAINTENANCE
Storage Tips
Cleaning - Outside...Make necessary repairs and then clean the
ATV thoroughly with a mild soap and warm water solution to re-
move all dirt and grime. Don’t use harsh detergents or high pres-
sure washers. Some detergents deteriorate rubber parts - use dish
soap type cleaners only. High pressure washers may force water
past seals. Drain the recoil housing.
Stabilize Fuel - Fill the fuel tank. Add Polaris Carbon Clean Fuel
Treatment or Polaris Fuel Stabilizer. Follow instructions on the con-
tainer for recommended amount. Carbon clean will also reduce the
possibility of bacterial growth in the fuel system. It’s best to allow
15-20 minutes of operation for the stabilizer to disperse through the
fuel in the tank and carburetor. Turn the fuel valve to “OFF” and drain
the carburetor bowl completely.
Oil And Filter Change - (4-Strokes) Warm the engine and change
oil and filter.
Air Filter / Air Box - Inspect and clean or replace the pre-cleaner and
air filter. Clean the air box and drain the sediment tube.
Breather Filter(s) - On 4-Strokes, inspect and clean or replace the
breather filter(s).
Inspect All Fluid Levels - Inspect the following fluid levels and
change if necessary: engine counter balance (2-strokes); front
gear case (shaft drive models); transmission; front hubs (AWD
models); brake fluid (change every two years or as required if fluid
looks dark or contaminated).
Drain Recoil Housing - Remove drain plug from recoil housing
and drain any moisture present.
Do not start the engine during the storage period. This will dis-
turb the protective film created by fogging.