Polaris 2001 ATV Universal ATV - Manual (Page 172)

161
MAINTENANCE
High Beam Headlight Adjustment (Gen IV)
The headlight beam can be adjusted to any position desired by
turning the adjusting knob located on the bottom right side of the
headlight pod.
1. Place the vehicle on a level surface with the headlight approxi-
mately 25’ (7.6 m) from a wall.
2. Measure the distance from the floor to the center of the head-
light and make a mark on the wall at the same height.
3. Start the engine and turn the headlight switch to high beam.
4. Observe headlight aim. The most intense part of the headlight
beam should be aimed 2″ (5.1 cm) below the mark placed on
the wall in step 2. NOTE: Rider weight must be included on the
seat.
5. Adjust beam to desired position by turning the adjustment
knob.