Grass Valley T2 Classic iDDR SP2 - Manual (Page 39)

June 11, 2010 T2 Maintenance Manual 39
Restoring to the factory default condition
12. Click "New Size" for the D: drive and enter the same value as in "Old Size" for the
D: drive.
13. Click
OK
.
14. Click
Yes
when the confirmation message is displayed.
• The writing process of the recovery image is performed. This process will take
a while.
15. When you see the completion message, remove the T2 Series Recovery Software
DVD from the DVD drive, and then click
Reset Computer
.
• The T2 restarts and a batch process for SID generation, the drive letter
assignment, and virtual memory allocation will run.
16. When you see the completion message, click
OK
and restart the T2.
• The T2 will restart in the maintenance mode.
• If you want to start up the T2 system in the normal mode, switch to the normal
mode after starting up the maintenance mode. For detailed instructions, refer to
"Restarting from the maintenance mode to the normal mode" on page 22 .
NOTE: It is recommended to initialize the data after the recovery is completed. For
detailed instructions, refer to "Initializing the data" on page 30 .
NOTE: Media files in the data drive (V: drive) cannot be used as they are even after
the recovery is completed. Copy the media files to the external storage device, and
then import them using the CommandCenter. For detailed instructions, refer to the
T2 User Manual.