Grass Valley T2 Classic iDDR SP2 - Manual (Page 22)

22 T2 Maintenance Manual June 11, 2010
Chapter 2 Maintenance Procedures
Exiting the maintenance mode
CAUTION: You must finish a diagnosis using the Maintenance Tools prior to
exiting the maintenance mode.
Restarting from the maintenance mode to the normal mode
The operation to switch from the maintenance mode to the normal mode is performed
from the Maintenance Tools main screen.
NOTE: You need to launch the Maintenance Tools beforehand. For more
information, refer to "Launching the Maintenance Tools" on page 24 .
1. In the Maintenance Tools main screen, select
CommandCenter
under "Next Boot
Mode".
2. Click
Restart
.
• After the restart, the CommandCenter is launched automatically.
Starting up the system without exiting the maintenance mode
This section describes the procedure to restart your system in the maintenance mode
from the Maintenance Tools main screen.
NOTE: If the Maintenance Tools is not running in the maintenance mode,
performing the normal restart operation from the Windows desktop will restart your
system without exiting the maintenance mode.
!