Grass Valley PVS 3000 July 2004 User Manual
Page 26
Set up PFR500 or PFR600 network settings
26
PVS 3000 & PVS3500 Installation Guide
23 February 2004
>>> CAUTION: Use only the PFR500 and PFR600 commands specified in this procedure.
Modifying some system parameters may render your RAID chassis inoperable.
Instructions
Text entered and displayed in terminal window
Press Enter to receive the
command prompt, then type
reboot
, and press Enter.
NOTE: If you fail to receive
the command prompt, check
cabling and verify Hyper
Terminal setup. Try cycling
the power on the RAID
Controller chassis. You can
leave the Expansion chassis
on. The boot screen should
appear.
Ciprico#
The boot screen appears. After
default settings are displayed,
press any key within 10 sec,
otherwise, the RAID
controller will initialize and
display a command prompt.
NOTE: If you miss the 10
second window, type
reboot
again when the
command prompt appears,
then press Enter, or try
cycling the power on the
RAID Controller chassis.
You can leave the Expansion
chassis on. The boot screen
should appear.
Rebooting now - this will kill this shell.
Ciprico Web Manager
Copyright Ciprico Inc. 2000
--------------------------------------------------------------------------
NETWORK INTERFACE PARAMETERS:
IP address on LAN is 192.168.0.11
LAN interface's subnet mask is 255.255.255.0
COMMUNICATION PARAMETERS:
Serial channels will use a baud rate of 9600
HARDWARE PARAMETERS:
This board's MAC Address is 0:20:46:11:14:23
APPLICATION PARAMETERS:
Boot Ciprico Network Server
Mail and SNMP notification will occur for Hardware changes,
Warnings, and Critical events.
SNMP TRAP CONFIGURATION:
TRAP COMMUNITY NAME 'public'
TRAP MANAGER #1 IP Address 192.168.0.10
After board is reset, start-up code will wait 10 seconds
--------------------------------------------------------------------------
To change any of this, press any key within 10 seconds.
Press Enter to modify
settings.
(M)odify any of this or (C)ontinue? [M]
Press Enter to configure a
LAN interface.
For each of the following questions, you can press
the value shown in braces, or you can enter a new value.
NETWORK INTERFACE PARAMETERS:
Do you want a LAN interface? [Y]
reboot