Grass Valley NV9604 v.1.1 - Manual (Page 27)

19
NV9604
User’s Guide
Four such modes (or behavioral models) apply. These letter codes identify, below, the NV9602
modes in which a button can operate:
S — single-destination mode
B — single-destination mode with breakaway
X — limited X-Y mode
M — multi-destination mode
Any — any mode
When the NV9604 is used by itself, the NV9604 has no modes, but can operate either as single-
destination panel (using the default destination) or as an X-Y panel.
Button Types
These are the button types available for NV9604 configurations:
Type Modes Description
Destination X The button selects a destination.
When the panel is an NV9602 extension, the destination name
appears in the ‘Destination’ display of the NV9602. The destination is
the target of a pending take, which will route a source to that
destination.
The nature of destination buttons differs according to your
configuration:
• Stand-alone panel.
When you assign a source button, one drop-down menus appear:
‘Destination Device’.
• NV9602 extension (you have checked ‘Use as Slave Panel’).
When you assign a destination button, two drop-down menus
appear: ‘Destination Device 1’ and ‘Destination Device 2’. These
correspond to the two destination sets. If there is a ‘Destination
Shift’ button on the NV9602 panel, the operator can switch
between the two sets. When the first set is selected, pressing the
button selects device 1. When the second set is selected, pressing
the button selects device 2.
Note that when an NV9602 is in multi-destination mode, the only
operable buttons on the NV9604 are salvo buttons.
Previous
Source S, B, X The button presets the previously routed source to the currently
selected destination. The operator must next press ‘Take’ to restore
the previous route. This function is useful when an operator makes a
route in error.
The button definition has no fields to configure.
The button does not restore the previous destination. If the user
changed the destination and presses ‘Previous Source’, the take will
not restore the previous route.
The button type is not available unless you have checked ‘Use as Slave
Panel’.