Grass Valley NV9605 v.1.1 - Manual (Page 27)

17
NV9605
User’s Guide
Checkbox Options
The checkbox options section is just below the panel options section, enclosed in the same
region:
A check in the box enables the option. Clearing the checkbox disables the option.
By default, all the check box options are clear.
The following items are the checkbox options:
• User-Programmable ID.
Allows the Panel ID to be changed locally at the control panel (in menu mode).
• Source Master Default.
Makes a control-level source the controlling device (or master device) by default. Otherwise,
the destination is the master, by default. (The option is specifically for use with NVISION
series machine control routers.)
“Source is master” is used for duplication, or broadcast routing, on a machine control level.
“Destination is master” is for machine-to-machine editing. If you do not select the “source
master default” option, you can place a ‘Source is Master’ button on the panel.
 Note: a ‘Source is Master’ button is a toggle that reverses the direction of data routing
for devices used in data level (machine control) takes.
• Hold preset default.
When this checkbox is checked, the panel powers up in “hold mode.” Otherwise it powers up
with hold mode off.
Hold mode, under limited X-Y mode, also allows a user to route a source to multiple destina-
tions simultaneously.
Hold mode also allows breakaway level patterns to remain selected after a take.
• Hide sources not configured on this panel.
Causes the names of source devices that are not presently configured for this particular
panel to be effectively hidden. When another panel changes the source to one not config-
ured for this panel, this panel displays asterisks instead.
• Use asterisks for breakaway.
Check the check box if you want to enable asterisks in the last character position of source
names. Cheark the check box if you do not want asterisks enabled.
Default Name Set System Name A list of “name sets” appears in the drop-down menu. The name
sets can be defined under the System Management pane of
NV9000-SE Utilities. Choose ‘System Name’ in this list if you do not
want, or do not care about, alternate device names. Do not choose
‘System Name’ if you are configuring any ‘Name Set Toggle’ but-
tons.