Grass Valley NV9605 v.1.1 - Manual (Page 26)

16
Configuration
Panel Options
Panel Options
The panel options section, at the right of the configuration page, has two parts: drop-down
menus and checkbox options. These are the drop-down menus:
These are its drop-down menu options:
Panel Behavioral
Model Limited X-Y In limited X-Y mode, takes occur from a single source to a single
destination (which is selectable). Takes are all-level.
Multi-destination In multi-destination mode, source buttons are configured with
destinations as well as sources. Thus, each source button com-
pletes a route to an individual destination. Takes are all-level.
Release Mode Normal Release This panel can release “locks” and “protects” set by the designated
user (at this panel or any other panel).
Force Release This panel can release locks and protects set by any user.
Default
Destination None After a reset, the panel has no default destination and displays no
destination device. (This is not recommended.)
‹device› The panel uses the specified device as the destination after a reset.
(The ‘Default State’ button also returns the panel to this destina-
tion.)
Status Monitor None The current source video is not sent to a monitor.
‹device› The current source video for the selected destination appears on
the specified monitor (device).
Data
Routing Mode Automatic If a control (data) level is involved in the route, make the route on
the control level even if the control port is in use on the source or
destination device.
Semi-automatic
(recommended) If the control port is in use on the source or destination device, take
all levels except control and allow the user to perform the control
level route by pressing ‘Take’ a second time. If ‘Take’ is not pressed
again, the route is cancelled.
If the control port is not in use, the control level take occurs auto-
matically.
Manual A take on the data level must be performed manually as a break-
away on the control level. The control level will never switch as part
of a multi-level take.