Grass Valley Media Conversion - Manual (Page 74)

Clock Builder Media Conversion Software
Page 74 Miranda Technologies Ltd
Building an Analogue clock
Once you have imported an analogue clock face you must set the reference
point. The reference point is the point about which the clock hands rotate and
would normally be the centre of the image. You can set the reference point
by:
♦ entering numbers in the X and Y centre boxes in the right-hand pane. As
you enter numbers or adjust them with the arrows a crosshair will be
shown on the face.
♦ dragging the cross hairs into the correct position. Point at the appropriate
line (cross hair), press and hold down the left mouse button, drag the line
to its new position using the mouse and then release the mouse button.