Grass Valley M-Series iVDR Upgrade Kit Installation - Manual (Page 46)

46 M-Series Upgrade Kit Manual 6 July 2004
Chapter 6 Installing the DVD-RW Drive
Attach DVD drive mounting brackets
Set DVD drive jumper to “slave” mode
Verify that the Master/Slave jumper on the rear of the drive is in the Slave position.
NOTE: Check the top of the DVD drive for a label describing jumper settings. The
following illustration is given as an example.
Power-off the iVDR and remove the power cord
1. Perform one of the following steps to power-off the iVDR:
• If AppCenter is running - In the AppCenter toolbar, select System | Shut Down ,
and select Shut Down in the Shut Down dialog box , then click OK . Wait for the
iVDR to shut down and power-off.
• If AppCenter is not running - In the Windows taskbar, click Start | Shut Down ,
and select Shut down , then click Ok . Wait for the iVDR to shut down and
power-off.
2. Remove the iVDR power cord.
Master/Slave
Jumper
(In Slave Position)
Interface
Connector
Power
Connector
DVD Drive Connector Example
Rear View
(Your drive may vary. Check label on top of drive.)