Grass Valley M-Series iVDR Upgrade Kit Installation - Manual (Page 40)

40 M-Series Upgrade Kit Manual 6 July 2004
Chapter 5 Installing the Front Panel
Modify VGA display setting
Perform this procedure to configure the iVDR display settings for 640 by 480 display
area which is required for front panel operation.
1. Power-on the iVDR.
Wait for Windows to initialize and AppCenter to start automatically.
2. Exit AppCenter as follows:
a. In the AppCenter toolbar, click System | Shutdown
b. Select Exit To Windows .
c. Click OK .
The Windows desktop appears.
3. Right-click on the Windows desktop, then choose Properties .
4. Select the Settings Tab , then set the Screen Area to 640 x 480 pixels.
5. Click Apply .
6. Select OK at the warning dialog.
7. Select Yes to keep the new settings.
8. Select OK to close the Display Properties dialog box.
Power-off and remove left access door
Press latch and
raise door 3
Power-off the iVDR and
disconnect the power
cable 1
Remove
screw
(Use T15 tip)
2
Slide off 4