Grass Valley Kayenne Installation Planning Guide Aug 30 2011 - Manual (Page 53)

KAYENNE — Installation Planning Guide 53
Section
4
System Cabling
Overview
The Kayenne system uses Ethernet, serial, and USB connections. Custom
multi-pin cabling is also used to connect the Kayenne Panel Control Unit
(PCU) to Kayenne control surface and Menu Panel components. The
Kayenne Video Processor Frame and PCU each have built-in Ethernet
switches. Tally outputs and GPI I/O (General Purpose Interface Input/
Output) control is also available (
Figure 55 ).
Figure 55. Kayenne System Communications Overview
CAUTION The facility network used for your Kayenne system (and other video produc-
tion equipment) should be kept separate from any external network, to
prevent network traffic from adversely affecting Kayenne system operation.
Kayenne system power is provided by power supplies built into the
Kayenne Video Processor Frame and Kayenne PCU. Power is routed to
8623266_39_
r2
Technical
Director’s
Laptop
CD-ROM
Drive
Disable Internet or
Wireless Connections
Isolate Kayenne System
from External Network
Ethernet
Serial Control
Custom Multi-Pin (Menu, 15m / 50ft max length)
Custom Multi-Pin (Panel, 15m / 50ft max length)
Maintenance Only (board front edge) *
Internal
Control
Kayenne Video Processor
Frame
Video
Processor
CPU
Compact
Flash
Image
Store
CPU
RAM
Only
Eh
te
rne
t Swi
tch
1
2
3
4
5
6
7
8
Panel Main LAN
Panel Aux LAN
(not used)
Eh
te
rne
t Swi
tch
1
2
3
4
5
6
7
8
Kayenne PCU
Menu
CPU
Hard
Disk
Menu
CPU
(option)
Hard
Disk
Panel
CPU
Compact
Flash
Menu Panel
Kayenne Control Panel
Remote Aux Panel
Local Aux Stripe
ME Stripe
ME Stripe
ME Stripe
(Up to 8 Stripe Connections)
USB
RS-422/485
Facility LAN
Switch
Ethernet
Router
Remote Aux Panel
Clip Store
(Image Store Clips)
USB (2)*
Keyboard, VGA*
RS-232*
RS-422/485 (8)
GPI In/Out
Tally
Keyboard, VGA*
RS-232*
USB (2)*
USB (4)
RS-232*
USB (2)*
Keyboard, VGA*