Grass Valley KayakDD-1 Installation - Manual (Page 88)

KayakDD-1 Digital Production Switcher
7.5.2 Supported GVG200 Commands
Name Command Code Remark
TRANSITION MODE COMMAND CA Only Write
TRANSITION RATE COMMAND CC/CD Only Write
TRANSITION PUSHBUTTON
SELECT COMMAND
FB
CROSSPOINT BUS COMMAND
C1-C4
(C1-CF for aux)
41-44
(41-4F for aux)
Crosspoint interpretation:
GVG code
Interpretation
01H...0x14 INPUT 1...20
15H ME1 OUT
16H ME2 OUT
17H CLEAN FEED
18H MAIN OUT
21H ME3 OUT
25H...27H COLOR BGD 1...3
30H...4BH INPUT 21...48
Aux busses:
The number of Aux Busses in not limited.
If the effect address is 07H (= Aux Crosspoint) the lower nibble of the
command code will be interpreted as the AUX bus number.
So up to 15 Aux Busses can be controlled.
PUSHBUTTON COMMAND
C6
(C7 for REV,KEY CUT
keyer 1, KEY CUT
keyer 2)
Only MIX ,WIPE, REV and KEY CUT are supported.
MIX and WIPE will switch the currently selected buttons for next transition to
the given state.
WIPE PATTERN SELECT
COMMAND
C8 Only Write
ALL STOP COMMAND F2
LEARN E-MEM REGISTER DA
RECALL E-MEM REGISTER DB
NOTE!
The GVG „DSK“ will always translated to the DD35 „PP“ mixer effect stage.
TIMING!
The standard GVG200 protocol timing will be used: Commands will be executed in the third field after response.
Planning and Installation Manual 87