Grass Valley KayakDD-1 Installation - Manual (Page 57)

KayakDD-1 Digital Production Switcher
7.1.1 Local Panel Test Mode 1 (Button Test)
Button combination:
Black Preset + Trans Preview + BDG
In this test mode, the logical address of the pressed button appears in the display.
7.1.2 Local Panel Test Mode 2 (LED Test)
Button combination:
Black Preset + Trans Preview + Key1
In this mode, the lamp of the pressed button is lit. The underfloor LEDs will be
switched on and off with the neighbouring bright button.
Special test buttons:
BGD, Key1 - Key4
→ Switch “On” underfloor LEDs on
Shift, Make (PGM+PST+Delegation)
→ Switch “Uncal” underfloor LEDs on
Key1 Cut / Key4 Cut
→ Switch the arrow (Fader) on
7.1.3 Local Panel Test Mode 3 (Group Test / On Air Highlight Test):
Button combination:
Black Preset + Trans Preview + Key2
In this mode, whole button groups are switched on and off by pressing any button in
the group. In the key bus, program and preset can be also switched between white and
red.
7.1.4 Local Panel Test Mode 4 (Connect Mode)
Button combination:
Black Preset + Trans Preview + Key3
This is no test mode, but a possibility to be connected to a mainframe without using
sidepanel. Simply enter the last byte of the IP address and confirm with .
Afterwards leave the test mode with Black Preset + Trans Preview + Key3, and then
one can control the mainframe.
56 Planning and Installation Manual