Grass Valley KayakDD-1 Installation - Manual (Page 43)

KayakDD-1 Digital Production Switcher
6.4 Control Panel Connectors
Figure 13 Control Panel Connectors
The rear of the KayakDD-1 Panel provides the power and system control connectors
for the system:
Jack Designation Note
J1 DC POWER IN DC power input connector for 48V operating voltage.
Connecting with the DC POWER OUT at the Processor
Frame. An interconnecting cable with a length of 10 m
(32ft.) is enclosed.
Alternatively optional cables of 50m (164 ft) and 100m (328
ft.) length can be used.
In case of longer distances (e.g. using fiberoptic cabling
(not supplied by Thomson Broadcast & Media Solutions) )
a separate 48V Power Supply Unit has to be connected.
Note:
The external power supply unit must comply with the
SELV (Safety Extra Low Voltage) standard exclusively.
ELV and TNV standard is not permitted!
M4 threaded pin Screw terminal for additional unit earthing
J2
J3 USB 1
USB 2 Connectors for USB devices, e.g. CD-ROM Drive, Mouse,
Keyboard or Memory Stick (only via USB 2).
Only recommended devices are supported.
For recommended Memory Stick refer to chapter 7.2.1
below.
Function of other devices can not be guaranteed.
J4 LAN RJ45 connector for connection to the Processor Frame.
An crossed interconnecting cable with a length of 20 m is
enclosed. Cables with lengths of 20m or 50m can be
ordered optionally.
42 Planning and Installation Manual