Epson LVP-X200A - Manual (Page 41)

41
ENGLISH
Caution:
• The light source lamp is fragile. Be careful not to
cut yourself with the fragments.
• The lamp life depends on the environment. For re-
placement lamps, please contact your dealer.
The projector automatically shuts off when
the lamp is used up in about 1,300 hours
and not used until lamp replacement.
11. Tighten up the screw of
the lamp lid using a
screwdriver (+).
How to reset the operation time meter
Plug in the power cord, switch on the projector and re-
set lamp time by pressing the
, and POWER but-
tons simultaneously.
• Lamp cannot be removed from the projector unless
setting the lamp exchanging metal.
• If you do not have the lamp exchanging metal, re-
move the metal from the new lamp and use it. Do
not touch the lamp directly. It may be broken and
may cause you to injure or burn or yourself.
Caution:
• For the lamp you have removed, do not spill liquid
on it, place it near flammable objects or where chil-
dren can touch it. Otherwise, it will cause injury or
fire.
• Be sure that the projector guide is firmly inserted
between the right and left lamp guides.
Do not touch the lamp directly, place a cloth over
the replacement lamp.
Important:
• The projector will not turn on if you do not secure
the lamp lid.
• The operation time meter must be reset after the
lamp has been replaced.
• Do not reset the operation time meter unless the
lamp has been replaced.
The life of the lamp
The average life of the lamp for the projector is about
1,000 hours of consecutive use. Life span may differ
according to operating environment, and may be shorter
than 1000 hours. Decreases in luminescence and/or
color brightness will indicate that the light source lamp
is in need of replacement. When lamp operation time
exceeds 1,000 hours, the indicator will flash alternately
between green and red (while the lamp is in operation;
when the lamp is not in operation, the indicator will
appear red only). When the lamp has been used for
about 1,250 hours, the message “LAMP!!.” will appear
on the screen. When the lamp has been used for about
1,300 hours, the projector will automatically shut off
for the safety of the lamp and the power indicator light
up in red. The projector cannot be used until the lamp
has been replaced.