Epson LVP-X200A - Manual (Page 11)

11
ENGLISH
Adjusting the angle of projection
Screen on a flat wall with a 90 degree angle to the floor
by adjusting two foot adjustments on the bottom of the
projector. If the angle cannot be corrected by them,
adjust the height and angle of screen.
1. Lift the projector to the right angle.
2. Press the release button for angle adjustment to take
the adjustment feet out of the projector.
3. Release the button and keep your hands away from
the projector.
4. Turn the both feet to right or left to adjust for proper
angle.
After using the projection,
5. Press the release button to take the projector down
slowly with holding it.
Important:
The image becomes trapezoid shape when the screen
or project is not level. Use KEYSTONE in ENHANCED
menu to adjust, however, the circumference of the im-
age may not be focused. See page 20.
• Screen on a flat wall with a 90˚ angle to the floor.
• Align projector to produce a full screen display as
illustrated on page 10.
• Distance from projector to screen must be
compatible with screen size chart on page 10. Note
distance from screen chart.
• If image is not square on screen, try adjusting the
front feet of the projector for proper angle.
Getting ready for projection
1. Connect the power cord provided to this projector
with the power jack of the projector.
2. Connect the power cord to the wall outlet.
3. Take off the lens cap.
4. Do not look directly into the lens when projector is
“ON”.
Warning:
• The lens cap is for protecting the lens. If you leave
the power on with the cap on, the cap may be warped.
Please remove the lens cap when you turn the power
on.
• A three-pin grounding type power plug is used with
the projector. Do not remove the grounding pin on
the power plug. If you are unable to insert the plug
into the outlet, contact your electrician to replace
your obsolete outlet.
• The supplied power cord is used for 120V only. Never
connect to any outlet or power supply having a dif-
ferent voltage or frequency. If you connect to the
power supply having a different voltage, please use
the appropriate power cord.
• Do not place an object on the power cord and keep
the projector away from heat source to avoid break-
ing the power cord. A broken of power cord can cause
fire or electric shock.
• Do not revise or alter the power cord otherwise it
may cause fire or electric shock.
Contact your dealer if the cord is broken.
Caution:
• Plug in firmly and unplug by holding the plug, not
by pulling the cable out.
• Do not plug in or out with wet hands. It may cause
an electric shock.
Plug in the provided
power cord directly.
ground
terminal
foot adjustment
screen