Grass Valley KMV-3901 Installation v.7.70 - Manual (Page 18)

12
Operation
Navigating the Local Control Panel Menu
Navigating the Local Control Panel Menu
The KMV-3901/3911 has operating parameters which may be adjusted locally at the
controller card interface. Press the Select button on the KMV-3901/3911 front card edge (see
Front Card-Edge Interface , on page 2) to assign the local control panel to operate the card.
Use the control panel buttons to navigate through the menu, as described below.
The complete menu structure is shown in Appendix A KMV-3901/3911 Local Control Panel ,
on page 29.
The local control panel displays a menu that can be navigated using the four buttons
located next to the display. The functionality of the buttons is as follows:
If no controls are operated for 30 seconds, the controller reverts to its normal standby
status, and the selected card’s Status LED reverts to its normal operating mode. If a
parameter was changed on the card but not submitted (SEL was not pressed) and the 30
second timeout occurs, the parameters will be confirmed as if the SEL button had been
pressed.
Saving a Restore Point to the Controller’s Non-Volatile Memory
The Densité CPU-ETH2 controller can be configured to automatically apply parameters
from a previously saved restore point, when you replace a card with another card of the
same type. In the case of a KMV-3901/3911 card the restore point includes the multiviewer’s
system name and networking parameters.
To save a restore point to the controller’s non-volatile memory, proceed as follows:
1 On the Densité frame’s local control panel, press the CONTROLLER button.
2 Press the [-] button repeatedly until RESTORE POINTS appears on the display, and then
press the SEL button.
3 Press the [-] button repeatedly until SAVE A CARD appears on the display, and then
press the SEL button.
4 Press the [-] button repeatedly until CARD # N-where N matches the slot number for the
Kaleido-Modular card whose configuration you wish to save-appears on the display,
and then press the SEL button.
[+] and [-] Used for menu navigation and value modification.
SEL Gives access to the next menu level. When a parameter value is shown, pressing this
button once enables modification of the value using the [+] and [-] buttons;
pressing a second time confirms the new value.
ESC Cancels the effect of parameter value changes that have not been confirmed;
pressing ESC causes the parameter to revert to its former value.
Pressing ESC moves the user back up to the previous menu level. At the main menu,
ESC does not exit the menu system. To exit, press the Select button on the front
edge of the card being controlled.