Grass Valley K2 Dyno PA Configuration Manual v.1.5 - Manual (Page 56)

Adding or replacing a K2 Summit system in an existing K2 Dyno
PA system
If using the Browse feature in Dyno PA, and a K2 Summit system needs to be added
or replaced, follow these steps.
1. When adding a new or replacing an existing K2 Summit system in a K2 Dyno PA
system, the FsNameServers file in the C:\SNFS\Config folder must be identical to
the other FsNameServers files in the system. This file contains the IP addresses of
the Control network ports on up to three name servers. You do not need to disable
the Write Filter to edit the FsNameServers file.
• If adding or replacing a K2 Summit system that is not being used as a host name
server, copy the FsNameServers file from one of the other machines in the setup
to the C:\SNFS\Config folder of the new machine.
• If replacing a K2 Summit system that is used as a host name server, the same
IP address for the Control network can be used on the replacement machine.
Since the identical FsNameServers file already exists on the other K2 Summit
systems or Dyno PA machines, copy the existing FsNameServers file from one
of these to the replacement machine.
• If adding a new host name server to an existing K2 Dyno PA system, the IP
address of the Control network for the new machine needs to be added to the
FsNameServers file of all the K2 Summit systems and Dyno PA machines in
the current setup. Either add this IP address to all the FsNameservers files or
update one FsNameServers file and then copy that file to the other machines.
You can have up to three host name servers in a setup.
2. Reboot the K2 Summit systems.
3. Reboot the K2 Dyno PA machines.
Related Links
Managing K2 Dyno PA on page 49
Restoring the K2 Summit system to a pre-DLC configuration
If you need to roll a K2 Summit system back to its pre-DLC configuration, you can
undo the changes.
Related Links
Managing K2 Dyno PA on page 49
Restoring the network adapter order on page 57
Undoing the DLC server configuration on page 57
56 K2 Dyno Production Assistant Configuration Manual version 1.5 15October 2010
Managing K2 Dyno PA