Grass Valley K2 Dyno PA Configuration Manual v.1.5 - Manual (Page 40)

The Enable button text changes to "Enabled" and the button is no longer active.
7. To disable the DLC server support, click the Disable button.
The Disable button text changes to "Disabled" and the button is no longer active.
8. Click the Close button to end the DLC configuration .
9. If the DLC server has been enabled, turn the write filter on.
10. Verify that the K2 Summit system is connected to the network.
CAUTION: If the K2 Summit system is not connected to the network,
connect a cable between the Control network to another network port.
Otherwise, when you reboot, the machine will not be able to access the file
system; you will not see the V: drive.
11. Reboot the machine.
12. Proceed to “Installing K2 Dyno PA”.
Related Links
Configuring the DLC server on page 37
Configuring the DLC server manually
Prerequisites:
• The K2 7.2.x software must be installed and configured as specified in the K2
Summit documentation.
40 K2 Dyno Production Assistant Configuration Manual version 1.5 15October 2010
Configuring the standalone K2 Summit system and K2 Dyno PA