Grass Valley K2 Dyno PA Configuration Manual v.1.5 - Manual (Page 36)

Related Links
About configuring K2 Summit SAN systems on page 22
About standalone K2 Summit system and K2 Dyno PA DLC configuration on page 34
Ordering the network adapters for K2 Dyno PA
Prerequisites:
• The K2 7.2.x software must be installed and configured as specified in the K2
Summit documentation.
• The file system name and storage disk labels on the K2 Summit system need to be
unique. If the system has been upgraded to 7.2.x from an earlier version, the file
system must be re-created with the Storage Utility tool, as specified in the K2
System Guide.
To enable the Browse feature on K2 Dyno PA, SNFS requires that the first network
adapter on the K2 Summit system must be the Control connection; the loopback adapter
cannot be the first network adapter.
1. Disable the write filter.
2. Reboot the machine.
3. If you are going to use the DLC Tool to configure the FsNameServers file, skip to
step 5. Otherwise, navigate to c:\snfs\config .
36 K2 Dyno Production Assistant Configuration Manual version 1.5 15October 2010
Configuring the standalone K2 Summit system and K2 Dyno PA