Grass Valley TR6442i - Manual (Page 50)

46
CommLink TR6442i
User Guide
Fig. A-15: Installing the connector board
Initially the board won't fit correctly - once the connectors are seated, pull the back
plate forward slightly and the board will fall into place.
21 Re-install the four self-tapping screws removed when the Rack Mount rear panel was
taken off of the main unit.
Fig. A-16: Reinstall the rear panel and tighten the main circuit board
22 Tighten (replace if you removed completely) the two screws holding the main circuit
board in place.
23 Re-install the Fiber Cable on to the ST Barrel. Make sure it locks into place.
24 Re-install the power connector. It is keyed to fit only one way.