Grass Valley TR6442i - Manual (Page 48)

44
CommLink TR6442i
User Guide
Fig. A-10: Removing the front panel
At this point, the connector panel should be removed from the unit (not shown).
12 Remove the ST Fiber Barrel from the Rack Mount version rear panel. The Barrel will be
used in the next step.
Fig. A-11: Remove the ST Fiber Barrel
13 Install the ST Fiber Barrel on the rear panel. The slotted side of the Barrel should be
installed so that it will face the exterior of the unit.
14 Remove the display circuit board from the Rack Mount version front panel. The board
and the four screws will be used in the next step.
Fig. A-12: The display circuit board screws